...
In the case above, after the subscriber receives the block that goes before the "Second Block", the sending of the "Sky" tunnel will start from the "First block" and the sending of blocks from the "Sun" tunnel (the current one) will cease, starting with the "Second block" (the block on which the condition is established). That is, the subscriber will not receive this block anymore.
| Note | ||
|---|---|---|
| ||
If the subscriber subscribed via LGT to the tunnel, reached the block where the START / STOP functions are activated, he was redirected to another tunnel and it will be signed again, then the redirection will not happen the second time. This is a protective function that aims to prevent looping of the tunnel, for example, if the redirection goes to the first block of the same tunnel. |
Movement on a particular branch when you click a certain button
...
The function of the inverse condition implies that the condition is not met. When you enable this function, you need to set the time that is given to perform the specified action in the condition. If during this time the condition is not fulfilled, then the actions (Start and / or Stop a certain tunnel) are performed.
In the case of on the screenshot above, if the "Message template" button to which the "One more template" template is attached has not been pressed for 5 minutes after receiving the message from the previous block, the messages from the "Sun" tunnel will start, starting with the "Second block" and stops sending messages from "Sky" tunnel stop sending, starting with the "First block". Keep in mind that if you do not specify which tunnel will be stopped (usually the current one), if the condition is met, in addition to starting sending messages from the tunnel set in the Start options, a message will come from the block on which the condition is set.
...